Mar
01
GY-601/611 Gyro setup
ByStep 1: Set gyro direction
Step 2: Set mode to (AVC)
Step 3: Set flight mode to 3D
Step 4: Set limit A, B anything over 120% is good
Step 5: Set gain to 35%, no more than 37% gain is needed.
Set start delay both A and B to 15%
Set stop delay both A and B to 40%
Note:
Start and stop delays are needed when flying a helicopter with a very stout torque tube design. Keep in mind that increasing the rudder end point will give you a faster pirouette rate on both gyros.
