Set head speeds, example Norm 1550
Idle1 1750
Idle2 1850
GRT – Set gear ratio
SWPT – Switch point, turn on
STSW – Stick switch, activate if using the stick as a switch
SwCd – Use to check status & verify GV-1 is working properly
Limit Idle/High/Cut – Set idle, full throttle, and cut positions.
Check that the sensor is reading is at 97%

Note:
To reset the GV-1 & GY-601, Transmitter is on, helicopter is off. Hold down both function keys & power up the helicopter till the GV-1/GY-601 screen flickers, about 3 seconds. Click function key until RESET appears. Then click the data key once, it will ask are you sure you want to reset? Click the data key again to reset all settings to factory defaults.

Tip: Your helicopter will only perform well if you spent the time making sure its built correctly and set up right. Take the time to learn the building and set-up process. Don’t just focus on flying.